User:Xiaoxin0

The easiest method to repair is often with a cement.mont blanc , Do the edges from the broken pieces fit together closely? If that's the case, a good two-part epoxy cement is best.pandora , I suggest an epoxy which cures to some clear color, not amber like the majority of.moncler coats , The brand name is Huges 330 Epoxy.ugg fashion , It's designed for gemstone material cementing.ugg boots cheap , A craft shop should have this cement or may order it for you personally. If not, try an exposy cement from the craft shop or home improvement store but don't obtain the quick setting kind. The best will harden within 2 hours. Quick set cements cure in five minutes and this is simply too little time to make a good joint from the broken ends. Clean the ends well with alcohol. This really is required to remove any traces of oils, etc. which will result in a joint failure later. Arrange a means to contain the ends together therefore the ends won't be moved before cement cures. Do that arrangement first and be certain it'll work. Then, mix the two part cement based on directions. Apply only enough cement to 1 broken edge to pay for the end after some cement. Push the pieces together and see if too much expires the perimeters. If so, wipe off before the cement begins to cure then place together again. Hold the pieces in place as mentioned already. Leave the remaining on the mixing paper or plastic, whatever can be used to combine the cement and place the mixer(toothpick, paper clip or other handy object) into the unused part. Once the object is cemented difficult on the unused part of the cement, you realize the jade can also be cured and could be handled. Excess if any might be carefully trimmed having a razor edge or left alone. Trimming of extruded cement will often leave a white and simply seen line. Sometimes it is best to leave the cement as is. If you have a significant amount of cement and a significant amount of is pushed in the joined edges, clean in acetone or nail polish remover. Clean well as you can. Then begin anew with a brand new mix of the epoxy. Don't use 'super glue' because this won't hold strongly for a long period of time. If you wish to try to perform the work, I believe you can. The first try may be messy and you may need to consider using a second time. If you want another person to do it, a jeweler should be able to cement the pieces together for your repair depends on the type of break in the bracelet. If the jade is broken and the ends of the break fit fairly well, a jeweler (or you if handy with such) may use a good epoxy cement to join the ends. An advised epoxy is Hughes 330, recommended because it cures water clear and it is very good with gemstone materials. Regardless, epoxy cements don't have any strength when first mixed. The cure brings the strength. By trying it yourself, dry fit first to locate a way to support the pieces throughout the 2 hour cure time. If the break is jagged and also the ends don't fit, the very best solution is to have a jeweler make a metal tube, either of silver or gold, to go over the broken ends and produce all together like a jade bangle with 'metal fittings'. The tube will need to have two ends angled to fit the bend from the jade pieces at each break. I do hope the break is neat and will fit back together. If that's the case, with a good cleaning to get rid of all traces of oils, etc., the epoxy means to fix the fix will work very well. If done carefully, you will see little to exhibit obviously in the break line.